Initiate a Network Discovery Process

How to use the rtr command to perform network discovery.

Use the HSS rtr --discover command to initiate a network discovery process. 
crayadm@smw> rtr --discover
The discovery process must be done on the system as a whole—it cannot be applied to individual partitions. Therefore, discovery will immediately fail if the system does not have partition p0 enabled.
The rtr --discover process should be used under the following circumstances:
  • During an initial install, after successful execution of xtdiscover
  • During the installation of additional cabinets in an existing installation, after the successful execution of xtdiscover
  • During an upgrade of optical cabling in a system, after all recabling is complete
The rtr --discover process is NOT required under the following circumstances:
  • On any single group system at any time, even those listed above
  • During a warmswap operation

See the rtr(8) man page for additional information.