stream replica edit

Permissions Required at the Source Cluster

To run this command, your user ID must have the following permissions:

readAce and writeAce on the volume
lookupdir on directories in the path
adminperm permission on the source stream

Note: The mapr user is not treated as a superuser. HPE Ezmeral Data Fabric Event Store does not allow the mapr user to run this command unless that user is given the relevant permission or permissions with access-control expressions.

Permissions Required at the Target Cluster

To run this command, your user ID must have the following permissions:

readAce and writeAce on the volume
lookupdir on directories in the path

Syntax

CLI

maprcli stream replica edit
	 -path <stream path> 
	 -replica <remote stream path> 
	[ -newreplica <renamed stream path> ]
	[ -throttle <throttle replication operations under load> ]
	[ -networkencryption <enable on-wire encryption> ]
	[ -synchronous <replicate to remote stream before acknowledging producers> ]
	[ -networkcompression <on-wire compression type: off|lz4|lzf|zlib> ]

REST http[s]://<host>:<port>/rest/stream/replica/edit?path=<path>&replica=<name>

Parameters

Parameter	Description
`path`	The path and name of the stream that you want to create a replica for.
`replica`	The path and name of the stream that you want to create as a replica of the stream that you specified with the `-path` parameter.
`newreplica`	Specifies a new name to give to the replica stream.
`throttle`	A boolean value that specifies whether to throttle replication operations. Throttle the replication stream to minimize the impact of the replication process on incoming operations during periods of heavy load. The values are `true` or `false`. The default is `false`. Throttling has two effects, both of which allow HPE Ezmeral Data Fabric Event Store to use more system resources to process new messages: Throttling slows down the rate at which changes to a stream are replicated. Throttling slows down the rate at which messages to be replicated are read from disk.
`networkencryption`	A boolean value that specifies whether or not to enable on-wire encryption. The values are `true` or `false`. The default is `false`. If you set the value to `true`, the local cluster and any other cluster that is part of the replication process must be enabled for security.
`synchronous`	A boolean value that specifies whether replication is synchronous or asynchronous. The values are `true` or `false`. The default is `false` and specifies asynchronous replication.
`networkcompression`	Specifies the type of compression to use when replicating messages. For more information, see Managing Compression.